CHEMICAL RESISTANT HI-WEAR COATING

Urochem 699 is a solvent free two-part polyether-based coating It yields an extremely flexible hi-build, hi-wear product with good chemical resistant and elongation properties.

• Apply a thin coat of primer by brush and allow the solvent to evaporate before applying coating or sealant. Once the primer loses its tackiness, re-prime.
• Walls and sloping areas should be coated with the thixotropic grade using a brush or roller. Note two coats are recommended and the intercoat time must not exceed 24Hours.

 Contains isocyanates. Ensure adequate ventilation. Do not use in confined spaces. Ensure adequate ventilation and the absence of any ignition source. Wear protective clothing. In case of eye contact wash well with water and obtain medical advice. Consult MSDS for more information.

• The correct preparation of the surfaces is critical. All surfaces should be clean, sound, and dry, and all laitance or surface contamination should be removed by wire brushing, grinding or grit blasting. Vacuum or blow with compressed air to ensure total removal of dust.
• On porous substrates, Urochem 614 primer is recommended.

Clean all tools immediately after use with Urochem 901. Once the material has polymerised it may only be removed mechanically.

It is used as a seamless flexible chemical resistant and hi-wear coating in containment or bunded areas where crack bridging of the substrate is essential.

Mix the activator and the base separately before adding the activator to the base and mixing thoroughly for a minimum of 3 minutes with a paddle mixer.