SINGLE PACK POLYURETHANE COATING/SEALER/PRIMER

 Urochem 614 is a single-pack, moisture cured polyurethane coating/primer based on an aromatic pre-polymer. The product is characterised by exceptional toughness and good flexibility. The rate of cure is influenced more by humidity and film thickness than temperature. Adhesion to most sound, suitably prepared surfaces is good and inter-coat times should not exceed 12 hours. As the product is based on an aromatic isocyanate, it will yellow and weather upon exposure to sunlight. This product displays good all-round chemical resistance.

• Brush, enamel roller or spray. A minimum of two coats is recommended.
• Overcoat within 4 hours.

 Contains organic solvents which are flammable. Do not use in confined spaces. Ensure adequate ventilation and the absence of any ignition source. Wear protective clothing. In case of eye contact wash well with water and obtain medical advice.

Please refer to product MSDS for further information.

Clean all equipment immediately after use with Urochem 901, as once the coating has polymerized it may only be removed mechanically.

• All surfaces must be clean, sound, and dry before application. Remove all loose material and ensure that there is no contamination by oils, grease, curing compounds etc. Steel surfaces must be blasted to at least SA 2.5, before applying a coat of a suitable anti-corrosive primer – Urochem 617.
• Ensure that all laitance has been removed from concrete surfaces and any omegas and other defects have been filled and patched with a suitable epoxy compound – Urochem 220

Used as a tough flexible water-resistant primer or coating on surfaces exposed to damp and moisture and where all round toughness is a requirement. It does possess some anti-graffiti properties.  

No allowance has been made for wastage.