EPOXY BEDDING MORTAR & ADHESIVE

 Urochem 230 is a filled, thixotropic, low slump solvent free, epoxy bedding mortar and adhesive. It has been specifically designed as a specialized adhesive for Urochem FPO (Flexible Polyolefine) bandage systems used in potable water reservoirs as well as wastewater reservoirs, as well as for bonding of Carbon Fibre strengthening strips. It is characterized by a good working life and fast cure, and bonds to saturated concrete.

 Specifically formulated for bonding of Urochem FPO and other polymer membranes to prepared concrete in Potable Water Reservoirs, and for bonding of carbon fibre reinforcing strips to prepared concrete.

Application for FPO Bandage system, see FPO Datasheet.  

Consult a specialist Structural Engineer for design criteria and specific application methods, as loads on various elements play an integral role in the application of these systems.

 All surfaces to be clean, sound, and dry, free from any oil laitance, dust or curing agents. Any exposed steel must be cleaned to a bright finish before application of Urochem 230. All dust must be removed by oil free compressed air or vacuum.

Clean all tools and equipment immediately after use with Urochem 901. Once the epoxy has set it may only be removed mechanically.

·Urochem 230 is supplied in a two-part kit, base, and activator in separate tins.

·Transfer the total quantity of activator into the base component and mix thoroughly using a slow speed electric drill fitted with a flat blade stirrer.

·Scrape down the sides of the can and the base and remix until the colour is uniform and free from streaks.

·Thorough mixing is essential and should take 5 to 10 minutes.

·Contact with the skin should be avoided.

·Wear gloves and protective clothing.

·In case of eye contact wash well with warm water and obtain medical advice.

·The cured material is not toxic.